Application · Lighting
Powerline communication for intelligent lighting.
Let lighting products communicate through the electrical wiring already in the building, instead of putting a wireless radio in every fixture.
A radio in every fixture
Networked lighting controls usually build a wireless mesh between hundreds or thousands of fixtures. It works in the showroom, then gets congested, fragile, and expensive at building scale.
Data on the lines already there
ZapPLC lets a switch, controller, or gateway send data to every luminaire over the existing power wiring. No wireless radio per fixture, and no mesh to commission and maintain.
ZapPLC for lighting
What it delivers
Fewer dropped nodes
A wired pathway is not affected by RF congestion between fixtures.
Lower installed cost
No wireless module in every fixture, and far less commissioning time.
Room to building scale
The same architecture covers one room or a whole facility.
Works with your platform
Sits beneath NLC, BMS, and Matter through one clean interface.
Where it fits
Built into the products you already make.
Bring ZapPLC to your lighting products.
Talk to us about integrating the ZapPLC communication layer into your product line.